Install the ADX files provided to allow communication with the Scanmaster G. Pair your device and follow these steps.įor an android device, install ALDLDroid. The unit will transmit data over bluetooth to a laptop or android device. While holding the recall button, if the mode button is also pressed the highest knock retard value will be displayed along with its MPH. while holding the recall button you will see the leanest captured data frame and the MPH that it occurred. The right button is the reset/recall button and will return the display to the default display as well as display any captured data. The left button on the unit is the Mode button and will step thru the various display modes.
The Scanmaster option for "Scanmaster G" must be turned on using the USB connection from PLC (at least version 2.6.0) before the datastream will work correctly. PowerLogger: (ensure the PowerLogger is up to date, (at least version 5.0).Stock Buick V6 Turbo: with all the variants that increase update speed and include injector pulsewidth and spark advance.The beta version supports the following data-streams: The unit will detect the incoming datastream type during power-up. The dashboard sheetmetal is will work as a good Ground. The ALD connector ground is a good quality ground connection.
Ground should be grounded to a good signal ground. +12v is connected to ignition power from the fusebox, Comms connects to either the ALDL signal (orange wire) at the ALDL connector under the dash. Some gauge pods are too tight to use the bracket, in which case a small dab of RTV sealant can be used to retain the unit.Ĭonnection: The unit has 3 connections on the back, +12v, Comms, and Ground. use the included bracket installed from the reverse side to retain it. Installation: It installs like any gauge in a 2-1/16" guage holder or pod. Turbo Buick ScanmasterG Preliminary instructions.